- Download an install Wireshark
- Select the interface you wish to capture from
- Apply a display filter from the list below
Filter for...
Filter string example
PTP ptp PTP Announce ptp.v2.message id = = 0xb PTP Path Delay Request (P2P) ptp.v2.message id = = 0x2 PTP Path Delay Response (P2P) ptp.v2.message id = = 0x3 PTP Path Delay Request (E2E) ptp.v2.message id = = 0x1 PTP Path Delay Response (E2E ptp.v2.message id = = 0x09 PTP Sync ptp.v2.message id = = 0x0 - Monitor for about 5-10 minutes
- Press the stop button
- Select File>Save
What you should see:
From the Master
*if you are using 1 step you will not see the follow_up Message
**if P2P is not configured you will not see the Peer_Delay_Req_Message
From the Slave
Third-party software disclaimer:
https://tekron.zendesk.com/knowledge/articles/360034131831